The Mission 3-in-1 cholesterol test strips are renowned for their accuracy. Used daily by thousands of health professionals and home users. With only 1 strip you determine your Total Cholesterol, HDL, LDL, Ttriglycerides and Cholesterol ratio!

Mission 3-in-1 Cholesterol Test Strips (x25)
✅ High-precision cholesterol test with the widest measuring range
✅ All your cholesterol levels with just 1 test strip.
✅ Determines: Total cholesterol, HDL, LDL, Triglycerides and cholesterol ratio!
✅ Easy to use
✅ Instant results in <1 minute
✅ Recommended by leading cardiovascular physicians and labs,
✅ #1 Cholesterol Test in Europe
✅ For professional and home use

Each pack contains:
✅ 25x Cholesterol Test Strips for use in Mission 3-in-1 Cholesterol Meter (sold separately)
✅ 25x capillary to absorb the blood
✅ 1 code chip for automatic calibration
✅ Instructions for use leaflet

FAQ use Mission Cholesterol 3-in-1 meter

What happens if the meter gives an E-5 error?

• There is not enough blood to perform a good measurement
• Possible cause: the pipette with blood is angled down instead of straight when applying the blood to the strip, causing air to get between the blood in the pipette
• Solution: Repeat the test with a refilled new pipette and a new strip

Why does the strip not absorb the blood completely?

• Sometimes the blood remains as a kind of ‘’bell’’ lie on the strip and it is not sucked in
• Possible cause: the blood was pressed out of the pipette too quickly/hard
• Solution: fill a new pipette and gradually squeeze the bead of the pipette

Why does the pipette not absorb blood?

• Possible cause: the air hole of the pipette (hole is in the ball) is held closed with the finger
• Solution: Try filling the pipette again without putting your finger on the air hole

Why does the meter say that the strip has expired when it should still be good according to the box?

• That shouldn't be possible. Out-of-date strips should be usable until the date stated on the packaging
• Possible cause: Meter date and time are not set correctly
• Solution: set the date of the meter correctly and repeat the measurement with the same strip (if there was no blood on it yet) or a new strip (if there was already blood on the strip)

What does an E-4 error mean?

• The batteries are too empty to perform a measurement
• Solution: Put 4 new  AAA alkaline batteries (1.5V) in the meter. Note: When replacing batteries, turn the meter off and check the meter's date and time settings after replacement